Selection
Selection
Motor + load numbers → fit check → dimension-sheet verification → inquiry. A calculator result is never an order confirmation.
Step 1: Motor + load numbers · Step 2: Fit check below · Step 3: Dimension-sheet verification · Step 4: Inquiry
Step 1: Motor + load numbers
Step 2: Fit check below
Step 3: Dimension-sheet verification
Step 4: Inquiry
Series page: DSP Rotary Table — frames 060–450 are table rows, not separate pages. Frame anchors: DSP Rotary Table DSP060 · DSP Rotary Table DSP085 · DSP Rotary Table DSP130 · DSP Rotary Table DSP200 · DSP Rotary Table DSP280 · DSP Rotary Table DSP450
What the calculators cannot decide
- Rated torque per planetary model → put it in the inquiry. (Per-model planetary torque is not hard-coded: the catalogue torque table is not clean enough, and the final fit must be checked against the dimension sheet.)
- Radial load → put it in the inquiry.
- Backlash grade for the exact frame → put it in the inquiry.
- Motor flange / shaft match → put it in the inquiry.
- Duty cycle (S1 / S5) → put it in the inquiry.
- Temperature, dust / moisture (IP65 vs. IP40) → put it in the inquiry.
- Custom flange / axis → put it in the inquiry.
Duty S1 / S5 note
S1 is continuous duty. S5 is intermittent duty (ED <60%, single run <20 min). Rotary-table life of 20,000 h is an intermittent-duty catalogue basis; planetary life of 20,000 h is the catalogue basis for the gearbox line. State your duty cycle in the inquiry — the fit check does not decide it.
Motor flange & shaft checklist
Before the inquiry is quotable, state: motor brand and model, flange size, shaft diameter and length, adapter-bushing need, output type (flange / shaft / hollow), and any custom flange or shaft requirement. “All brands” motors are a catalogue positioning statement via adapter-bushing, not a guarantee for an unlisted motor.
Compare (up to 3)
DSP Rotary Table
Frames 060–450, IP40.
DLS
Frames 060–200, stepping.
DSR
Frames 060–200.